Rohde & Schwarz MXO 4 Series - MSO Data

Remote control commandsMXO 4 Series
854User Manual 1335.5337.02 ─ 07
Parameters:
<LevelCoupling> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Level coupling" on page 424
PBUS<pb>:THReshold<n> <Threshold>
Sets the logical threshold for the indicated channel group.
Alternatively you can use the following commands:
●
To select from a list of predefined technologies: PBUS<pb>:TECHnology
●
For logic 1: DIGital<m>:THReshold
See also DIGital<m>:THCoupling on page 845.
Suffix:
<pb>
.
1...4, index of the logic group
<n> 1..4
Selects the channel group:
1 = digital channels 0..3;
2 = digital channels 4..7
3 = digital channels 8..11
4 = digital channels 12..15
Parameters:
<Threshold>
Usage: Asynchronous command
Manual operation: See "Technology, Threshold" on page 424
17.17.3 MSO data
The remote data transfer from the instrument to the controlling computer is performed
using the following commands:
DIGital<m>:DATA:HEADer?............................................................................................ 854
DIGital<m>:DATA[:VALues]?........................................................................................... 855
PBUS<pb>:DATA:FORMat..............................................................................................855
PBUS<pb>:DATA:HEADer?............................................................................................ 856
PBUS<pb>:DATA[:VALues]?........................................................................................... 856
DIGital<m>:DATA:HEADer?
Returns the header of digital channel data
Mixed signal option (option R&S
MXO4-B1)