Waveform generator (option R&S MXO4-B6)MXO 4 Series
447User Manual 1335.5337.02 ─ 07
Remote command:
WGENerator<wg>:COUPling:AMPLitude on page 875
Amplitude parameters
Couples all amplitude parameters of "Gen1" and "Gen2" including the load. The values
are taken from the currently selected generator.
Remote command:
WGENerator<wg>:COUPling[:FREQuency] on page 875
Phase Gen1 - Gen2
Sets the phase shift between the waveform of Gen1 and Gen2 when the frequency
parameters of the two waveforms are coupled.
Remote command:
WGENerator<wg>:COUPling:PHASeshift on page 875
15.3 Configuring the waveform generator
This chapter explains step by step how to configure the waveform generator.
● Configuring a function waveform...........................................................................447
● Configuring a modulation waveform......................................................................447
● Configuring a sine sweep waveform..................................................................... 449
● Configuring an arbitrary waveform........................................................................449
15.3.1 Configuring a function waveform
1. Tap the "Gen" signal activator.
2. Select the tab of the generator that you want to configure: "Gen"1 or "Gen"2.
3. In the "Setup" tab, select the "Function type" that you want to generate, e.g. "Sine".
4. Depending on the selected "Function type", configure the settings of the waveform
like "Frequency" and "Amplitude".
5. If necessary, change the "User load" settings, or add "Noise level in %" to the
waveform.
6. Set "State" = "On" to output the waveform at the output connector of the waveform
generator.
15.3.2 Configuring a modulation waveform
Generating an AM modulated waveform
1. Tap the "Gen" signal activator.
Configuring the waveform generator
To Next Page
Loading...
