Rohde & Schwarz MXO 4 Series - History

Remote control commandsMXO 4 Series
587User Manual 1335.5337.02 ─ 07
17.10.3 History
ACQuire:HISTory:CURRent.............................................................................................587
ACQuire:HISTory:PLAY.................................................................................................. 587
ACQuire:HISTory:REPLay...............................................................................................587
ACQuire:HISTory:STARt................................................................................................. 588
ACQuire:HISTory:STOP..................................................................................................588
ACQuire:HISTory:TPACq................................................................................................ 588
ACQuire:HISTory:TSABsolute?........................................................................................588
ACQuire:HISTory:TSDate?..............................................................................................589
ACQuire:HISTory:TSRelative?.........................................................................................589
ACQuire:HISTory:TSRReference?................................................................................... 589
ACQuire:HISTory[:STATe]............................................................................................... 589
ACQuire:HISTory:CURRent <CurrentAcqIndex>
Accesses a particular acquisition in the memory to display it, or to save it. The newest
acquisition always has the index "0". Older acquisitions have a negative index.
Parameters:
<CurrentAcqIndex> Range: -2147483648 to 0
Increment: 1
*RST: 0
Usage: Asynchronous command
Manual operation: See "Current acq" on page 194
ACQuire:HISTory:PLAY
Starts and stops the replay of the history waveforms.
Usage:
Event
Asynchronous command
Manual operation: See "Player" on page 194
ACQuire:HISTory:REPLay <AutoRepeat>
If enabled, the replay of the history waveform sequence repeats automatically.
Otherwise, the replay stops at the stop index set with ACQuire:HISTory:STOP
on page 588.
Parameters:
<AutoRepeat> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Auto repeat" on page 196
Waveform analysis