Protocol analysisMXO 4 Series
325User Manual 1335.5337.02 ─ 07
SBUS<sb>:SPI:SCLK:HYSTeresis on page 711
SBUS<sb>:SPI:CSELect:HYSTeresis on page 708
SBUS<sb>:SPI:MISO:THReshold on page 710
SBUS<sb>:SPI:MOSI:THReshold on page 711
SBUS<sb>:SPI:SCLK:THReshold on page 712
SBUS<sb>:SPI:CSELect:THReshold on page 709
Show threshold lines
If enabled, the threshold lines are displayed in the diagram.
The label of the threshold line is set according to the signal that it is referring to, see
also Show threshold lines.
Remote command:
SBUS<m>:THReshold on page 705
13.2.2.3 Display settings
For details about the display settings, see Chapter 13.1.4, "Display", on page 315.
13.2.3 SPI filter
Access:[Apps] key > "Protocol" tab > "SPI" > "Filter" tab
SPI bus (option R&S MXO4-K510)
To Next Page
Loading...
