Rohde & Schwarz MXO 4 Series - Page 708

Remote control commandsMXO 4 Series
708User Manual 1335.5337.02 ─ 07
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<BitOrder> LSBF | MSBF
*RST: MSBF
Usage: Asynchronous command
Manual operation: See "Bit order" on page 323
SBUS<sb>:SPI:CSELect:HYSTeresis
<Hysteresis>
Sets a value for the hysteresis for the CS channel.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Hysteresis>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 324
SBUS<sb>:SPI:CSELect:POLarity <CSPolarity>
Selects if the transmitted signal for the respective line is active high (high = 1) or active
low (low = 1).
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<CSPolarity> ACTLow | ACTHigh
*RST: ACTLow
Usage: Asynchronous command
Manual operation: See "Polarity: MOSI, MISO, CS" on page 323
SBUS<sb>:SPI:CSELect:SOURce CSSource
Sets the input channel of the CS line.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
CSSource C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9
| D10 | D11 | D12 | D13 | D14 | D15 | M1 | M2 | M3 | M4 | M5 |
R1 | R2 | R3 | R4
Usage: Asynchronous command
Protocols