Rohde & Schwarz MXO 4 Series - Page 709

Remote control commandsMXO 4 Series
709User Manual 1335.5337.02 ─ 07
Manual operation: See "SCLK,MOSI,MISO,CS" on page 323
SBUS<sb>:SPI:CSELect:THReshold <Threshold>
Sets a user-defined threshold value for the line.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Threshold>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 324
SBUS<sb>:SPI:MISO:HYSTeresis
<Hysteresis>
Sets a value for the hysteresis for the MISO channel.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Hysteresis>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 324
SBUS<sb>:SPI:MISO:POLarity <MISOPolarity>
Selects if the transmitted signal for the respective line is active high (high = 1) or active
low (low = 1).
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<MISOPolarity> ACTLow | ACTHigh
*RST: ACTHigh
Usage: Asynchronous command
Manual operation: See "Polarity: MOSI, MISO, CS" on page 323
SBUS<sb>:SPI:MISO:SOURce MISOSource
Sets the input channel of the MISO line.
Suffix:
<sb>
.
1...4, index of the serial bus
Protocols