MeasurementsMXO 4 Series
221User Manual 1335.5337.02 ─ 07
Statistics
In addition to the current measurement results, you can enable a statistic evaluation. It
returns the current, minimum and maximum measurement values, the average and
standard deviation, and the number of measured waveforms. The results are shown in
a separate tab below the grid. If the cursor measurement is active simultaneously, its
results are shown beside the statistics results.
9.2.2 Gate settings for measurements
Gate areas limit the measurement to a user-defined range of the waveform. The gate
settings are defined on the "Gate" tab.
You can define up to 2 separate gates for the measurement analysis. Then, you assign
the measurements to the gates.
Access: [Measure] > "Gate" tab
Add
Activates a new gate.
Automatic measurements
To Next Page
Loading...
