Rohde & Schwarz MXO 4 Series - Power Analysis (Option R&S MXO4-K31)

Remote control commandsMXO 4 Series
675User Manual 1335.5337.02 ─ 07
17.15.1.6 Frequency response analysis export
EXPort:RESult:SELect:FRA:MARGin............................................................................... 675
EXPort:RESult:SELect:FRA:MARKer............................................................................... 675
EXPort:RESult:SELect:FRA:RESult................................................................................. 675
EXPort:RESult:SELect:FRA:MARGin <MarginResult>
If enabled, includes the margin results in the results export file of the FRA.
Parameters:
<MarginResult> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "FRA results" on page 270
EXPort:RESult:SELect:FRA:MARKer <MarkerResult>
If enabled, includes the marker results in the results export file of the FRA.
Parameters:
<MarkerResult> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "FRA results" on page 270
EXPort:RESult:SELect:FRA:RESult <Result>
If enabled, includes the frequency response analysis results, including the frequency,
gain, phase and amplitude, in the results export file of the FRA.
Parameters:
<Result> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "FRA results" on page 270
17.15.2 Power analysis (option R&S MXO4-K31)
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
Applications