Rohde & Schwarz MXO 4 Series - Settings for Cursor Measurements

MeasurementsMXO 4 Series
210User Manual 1335.5337.02 ─ 07
To add labels to cursor lines
1. Press the [Cursor] key.
2. Select the subtab for the cursor set you want to configure.
3. Select the "Advanced" tab.
4. Enter a label for "Vertical cursor 1", "Vertical cursor 2", "Horizontal cursor 1", "Hori-
zontal cursor 2".
5. Enable "Show label".
9.1.3 Settings for cursor measurements
Cursor measurements are configured in the "Cursor" dialog box.
9.1.3.1 Setup tab
The "Setup" tab contains the settings for cursor measurements.
Cursor measurements