Rohde & Schwarz MXO 4 Series - Reference Waveforms

Remote control commandsMXO 4 Series
590User Manual 1335.5337.02 ─ 07
Usage: Asynchronous command
Manual operation: See "Show history" on page 194
17.10.4 Reference waveforms
● Setup.....................................................................................................................590
● Scaling.................................................................................................................. 593
● Reference waveform data export..........................................................................597
17.10.4.1 Setup
REFCurve<rc>:ABORt....................................................................................................590
REFCurve<rc>:CLEar.....................................................................................................590
REFCurve<rc>:NAME.................................................................................................... 591
REFCurve<rc>:OFFSet.................................................................................................. 591
REFCurve<rc>:OPEN.....................................................................................................591
REFCurve<rc>:RESTore.................................................................................................591
REFCurve<rc>:SAVE..................................................................................................... 592
REFCurve<rc>:SOURce.................................................................................................592
REFCurve<rc>:STATe.....................................................................................................592
REFCurve<rc>:UPDate.................................................................................................. 592
REFCurve<rc>:ABORt
Aborts a running reference waveform export, which was started with REFCurve<rc>:
SAVE, or a running reference waveform update, which was started with
REFCurve<rc>:UPDate on page 592.
Suffix:
<rc>
.
1...4, index of the reference waveform
Usage: Event
Asynchronous command
Manual operation: See "Save" on page 201
REFCurve<rc>:CLEar
The selected reference waveform disappears, its memory is deleted.
Suffix:
<rc>
.
1...4, index of the reference waveform
Usage: Setting only
Asynchronous command
Manual operation: See "Clear" on page 201
Waveform analysis