Rohde & Schwarz MXO 4 Series - Page 597

Remote control commandsMXO 4 Series
597User Manual 1335.5337.02 ─ 07
REFCurve<rc>:VMODe <VerticalMode>
Selects the coupling of vertical settings.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<VerticalMode> COUPled | INDependent
COUPled
Vertical position and scale of the source are used.
INDependent
Scaling and position can be set specific to the reference wave-
form.
*RST: INDependent
Usage: Asynchronous command
Manual operation: See "Mode" on page 203
17.10.4.3
Reference waveform data export
Commands to transmit the data of reference waveforms are listed below. Commands
for saving waveform data to file are described in Chapter 17.11.4, "Waveform export to
file", on page 606.
REFCurve<rc>:DATA:STYPe?.........................................................................................597
REFCurve<rc>:DATA:HEADer?....................................................................................... 597
REFCurve<rc>:DATA[:VALues]?...................................................................................... 598
REFCurve<rc>:DATA:STYPe?
Returns the signal type of the source of the reference waveform.
Suffix:
<rc>
.
1...4, index of the reference waveform
Return values:
<SignalType>
Usage: Query only
Asynchronous command
REFCurve<rc>:DATA:HEADer?
Returns information on the reference waveform.
Table 17-4: Header data
Position Meaning Example
1 XStart in s -9.477E-008 = - 94,77 ns
2 XStop in s 9.477E-008 = 94,77 ns
Waveform analysis