Protocol analysisMXO 4 Series
408User Manual 1335.5337.02 ─ 07
SBUS<sb>:SPMI:SCLK:HYSTeresis on page 814
SBUS<sb>:SPMI:SDATa:HYSTeresis on page 814
Show threshold lines
If enabled, the threshold lines are displayed in the diagram.
The label of the threshold line is set according to the signal that it is referring to, see
also Show threshold lines.
Remote command:
SBUS<m>:THReshold on page 705
13.7.1.3 Display settings
For details about the display settings, see Chapter 13.1.4, "Display", on page 315.
Decode layer
Selects the decode layer.
Decoding is performed in several steps, and the end results are presented in the
decode table. The decode layer selects an interim step for which the decoding result is
shown in the honeycomb display.
13.7.2 SPMI filter
Access: [Apps] key > "Protocol" tab > "SPMI" > "Filter" tab
SPMI (option R&S MXO4-K550)
To Next Page
Loading...
