Rohde & Schwarz MXO 4 Series - Option Settings; Software Options Settings

Instrument setupMXO 4 Series
80User Manual 1335.5337.02 ─ 07
The instrument uses the system time of the operating system, but you can change date
and time for the MXO 4 firmware.
1. To change the date:
a) Tap the date button.
b) Select the date in the calendar.
c) Tap the blue calendar icon to close the calendar.
2. To change the time, move the hour, minute and second sliders to the required val-
ues.
3. Adjust the "Prefix" and "Suffix" to indicate your location.
4. Tap "Apply".
Remote command:
●
SYSTem:DATE on page 485
●
SYSTem:TIME on page 487
5.2 Option settings
Additional options for the MXO 4 are enabled using a license key. To obtain the license
key, consult your sales representative.
You can obtain registered or unregistered licenses.
Unregistered licenses
Unregistered licenses are not assigned to a particular instrument. The instrument
accepts only registered licenses. If your license is delivered unregistered, use the
online tool R&S License Manager to register the license for your instrument. The regis-
tration of a permanent license is irreversible, so ensure that you register it for the cor-
rect instrument. The address of the tool is https://extranet.rohde-schwarz.com/service.
For registration, you need the device ID of the instrument on which the option will be
installed.
5.2.1 Software options settings
Access: "Settings" > "Options" > "Software"
Option settings