TriggerMXO 4 Series
149User Manual 1335.5337.02 ─ 07
"AC 1 MΩ"
Connection with 1 MΩ termination through DC capacitor, removes DC
and very low-frequency components. The waveform is centered on
zero volts.
Remote command:
TRIGger:ANEDge:COUPling on page 545
Filter, Cut-off
Selects the filter mode for the external trigger signal, and sets the cut-off frequency.
"Off"
The trigger signal is not filtered.
"LF reject"
Frequencies lower than the "Cut-off" frequency are rejected, higher
frequencies pass the filter.
"RF reject"
Frequencies higher than the "Cut-off" frequency are rejected, lower
frequencies pass the filter.
Remote command:
TRIGger:ANEDge:FILTer on page 545
TRIGger:ANEDge:CUToff:HIGHpass on page 546
TRIGger:ANEDge:CUToff:LOWPass on page 546
Trigger noise reject
Enables an automatic hysteresis on the trigger level to avoid unwanted trigger events
caused by noise.
Remote command:
TRIGger:ANEDge:NREJect on page 546
7.4.3 Glitch trigger
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Glitch"
The glitch trigger detects pulses shorter or longer than a specified time. It identifies
deviation from the nominal data rate and helps to analyze causes of even rare glitches
and their effects on other signals.
This section describes the trigger-type specific settings. For settings that apply to all
trigger types, see Chapter 7.2, "Common trigger settings", on page 142.
Trigger types
To Next Page
Loading...
