Rohde & Schwarz MXO 4 Series - Waveform Data Export

Remote control commandsMXO 4 Series
514User Manual 1335.5337.02 ─ 07
CHANnel<ch>:IMPedance <Impedance>
Sets the impedance of the connected probe for power calculations and measurements.
Suffix:
<ch>
.
1 to 4, index of the analog channel
Parameters:
<Impedance> Range: 0.1 to 100000
Increment: 1
*RST: 50
Default unit: Ω
Usage: Asynchronous command
Manual operation: See "Impedance" on page 124
17.8.5 Waveform data export
To set the export data format, see FORMat[:DATA].
CHANnel<ch>:DATA:HEADer?........................................................................................514
CHANnel<ch>:DATA:VALues?.........................................................................................515
CHANnel<ch>:DATA:HEADer?
Returns the header of channel waveform data. The header contains attributes of the
waveform.
Table 17-2: Header data
Position Meaning Example
1 XStart in s -9.477E-008 = - 94,77 ns
2 XStop in s 9.477E-008 = 94,77 ns
3 Record length of the waveform in Samples 200000
4 Number of values per sample interval. For most
waveforms, the result is 1. For peak detect and
envelope waveforms, it is 2. If the number is 2, the
number of returned values is twice the number of
samples (record length).
1
Suffix:
<ch>
.
1 to 4, index of the analog channel
Example:
CHAN1:WAV1:DATA:HEAD?
-9.477E-008,9.477E-008,200000,1
Usage: Query only
Asynchronous command
Acquisition and setup