Rohde & Schwarz MXO 4 Series - State Trigger

Remote control commandsMXO 4 Series
561User Manual 1335.5337.02 ─ 07
TRIGger:EVENt<ev>:SETHold:HTIMe <HoldTime>
Sets the minimum time after the clock edge while the data signal must stay steady
above or below the data level.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Parameters:
<HoldTime> Range: -9.9999E-08 to 1E-07
Increment: 1E-09
*RST: 0
Default unit: s
Usage: Asynchronous command
Manual operation: See "Hold time" on page 163
TRIGger:EVENt<ev>:SETHold:STIMe <SetupTime>
Sets the minimum time before the clock edge while the data signal must stay steady
above or below the data level.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Parameters:
<SetupTime> Range: -9.9999E-08 to 1E-07
Increment: 1E-09
*RST: 0
Default unit: s
Usage: Asynchronous command
Manual operation: See "Setup time" on page 163
17.9.12 State trigger
TRIGger:EVENt<ev>:STATe:QUALify:ANALog:CHAN<n>:HLX........................................... 561
TRIGger:EVENt<ev>:STATe:QUALify:LOGic.....................................................................562
TRIGger:EVENt<ev>:STATe:SLOPe.................................................................................562
TRIGger:EVENt<ev>:STATe:QUALify:DIGital:LOGic.......................................................... 562
TRIGger:EVENt<ev>:STATe:QUALify:DIGital:CHAN<n>:HLX............................................. 563
TRIGger:EVENt<ev>:STATe:QUALify:ANALog:CHAN<n>:HLX <HLX>
Set the state for each channel. For the state trigger, the clock source is indicated and
does not get a state.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
<n> 1 to 4, index of the analog channel
Trigger