Rohde & Schwarz MXO 4 Series - Waveform Generator (Option R&S MXO4-B6); Waveform Generator Setup

Remote control commandsMXO 4 Series
857User Manual 1335.5337.02 ─ 07
Usage: Query only
Asynchronous command
Manual operation: See "Data format" on page 425
17.18 Waveform generator (option R&S MXO4-B6)
This chapter describes the remote commands of the waveform generator.
The instrument preset does not affect the generator settings. Each generator has its
own preset: WGENerator<wg>:PRESet.
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command sequence and synchroni-
zation"
17.18.1 Waveform generator setup
17.18.1.1 General settings
WGENerator<wg>:FREQuency....................................................................................... 857
WGENerator<wg>:FUNCtion:PULSe[:WIDTh]...................................................................858
WGENerator<wg>:FUNCtion:RAMP[:SYMMetry]...............................................................858
WGENerator<wg>:FUNCtion[:SELect]..............................................................................858
WGENerator<wg>:FUNCtion[:SQUare]:DCYCle................................................................859
WGENerator<wg>:OUTPut[:LOAD]..................................................................................859
WGENerator<wg>:PERiod..............................................................................................859
WGENerator<wg>:PRESet............................................................................................. 860
WGENerator<wg>:VOLTage:DCLevel.............................................................................. 860
WGENerator<wg>:VOLTage:HIGH...................................................................................860
WGENerator<wg>:VOLTage:INVersion.............................................................................861
WGENerator<wg>:VOLTage:LOW................................................................................... 861
WGENerator<wg>:VOLTage:OFFSet............................................................................... 861
WGENerator<wg>:VOLTage[:VPP].................................................................................. 862
WGENerator<wg>[:ENABle]............................................................................................862
WGENerator<wg>:FREQuency <Frequency>
Sets the frequency of the waveform.
Waveform generator (option R&S
MXO4-B6)