Rohde & Schwarz MXO 4 Series - Interval Trigger

Remote control commandsMXO 4 Series
555User Manual 1335.5337.02 ─ 07
TRIGger:EVENt<ev>:TIMeout:RANGe <TimeoutMode>
Sets the relation of the signal level to the trigger level for the timeout trigger.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Parameters:
<TimeoutMode> HIGH | LOW | EITHer
HIGH = stays high, the signal level stays above the trigger level.
LOW = stays low, the signal level stays below the trigger level.
EITHer = stays high or low.
*RST: HIGH
Usage: Asynchronous command
Manual operation: See "Range" on page 157
TRIGger:EVENt<ev>:TIMeout:TIME
<Time>
Sets the time limit for the timeout at which the instrument triggers.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Parameters:
<Time> Range: 1E-10 to 10000
Increment: 1E-07
*RST: 1E-07
Default unit: s
Usage: Asynchronous command
Manual operation: See "Time" on page 157
17.9.9 Interval trigger
TRIGger:EVENt<ev>:INTerval:DELTa...............................................................................555
TRIGger:EVENt<ev>:INTerval:RANGe............................................................................. 556
TRIGger:EVENt<ev>:INTerval:SLOPe..............................................................................556
TRIGger:EVENt<ev>:INTerval:WIDTh.............................................................................. 557
TRIGger:EVENt<ev>:INTerval:DELTa <WidthDelta>
Sets a range around the interval width value specified with TRIGger:EVENt<ev>:
INTerval:WIDTh.
Suffix:
<ev>
.
1 = A-trigger, 2 = B-trigger, 3 = reset event
Trigger