Operating the instrumentMXO 4 Series
63User Manual 1335.5337.02 ─ 07
Add cursor
Adds a cursor set. Select the cursor type and the source to be measured.
See also: Chapter 9.1, "Cursor measurements", on page 207.
Measure
Adds one or more measurements to the waveform.
Tap the icon, and select the category and the measurements in the overlay menu.
Select the waveform to be measured, and close the overlay menu.
Add gate
Creates a new gate.
Tap the icon, and then tap the diagram or draw a rectangle to define the limits of the
gate. The "Gate" dialog opens, where you can adjust the geate settings and add mea-
surements to use the gate.
Edit spectrum
Edit the existing spectrum settings in the overlay menu.
Delete
Removes waveforms, diagrams and zooms from the display.
Tap the "Delete" icon. A recycle bin icon marks all objects that can be deleted. Tap this
icon to remove an object. Tap the "Delete" icon again to disable the function.
File browser
Opens the file browser dialog.
See also: Chapter 12.5, "File browser dialog", on page 310.
4.7 Using the selection menu
The selection menu, or comb menu, helps select objects on the screen if several
objects are close beside. These objects are, for example, waveforms, zoom edges,
gate limits, and cursor lines. When you tap or click a point in a diagram, the instrument
determines the objects around the point and provides an appropriate menu. Each
found object is represented by a comb. If more than 6 objects are detected, related
objects are grouped to submenus. The selection menu is created and arranged anew
at each finger tap, there are no predefined positions for the objects.
1. Tap the screen at the point of interest.
The selection menu provides all objects that were found around the point. In the
image below, the objects of "Cursor Cu1" and "Zoom Z1" are grouped in subme-
nus. The right arrow indicates that a submenu is available.
Using the selection menu
To Next Page
Loading...
