Rohde & Schwarz MXO 4 Series - Automatic Measurements; General Settings

Remote control commandsMXO 4 Series
613User Manual 1335.5337.02 ─ 07
HCOPy:SSD <ShwSetDialogScpi>
If enabled, the currently open dialog box is included in the screenshot.
Parameters:
<ShwSetDialogScpi> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Show setup dialog" on page 309
HCOPy:WBKG
<WhiteBackground>
Inverts the background color, so you can picture waveforms with normal waveform col-
ors on white background.
If both HCOPy:WBKG and HCOPy:DEVice<m>:INVerse are ON, the instrument
inverts the background twice, and it appears black.
Parameters:
<WhiteBackground> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "White background" on page 309
17.12 Automatic measurements
This chapter contains all remote commands to set up automatic measurements and to
analyze the measurement results.
Measurement suffix <mg>
The suffix <mg> indicates the number of the measurement, for which the command
takes effect.
17.12.1 General settings
MEASurement<mg>:COUNt?..........................................................................................614
MEASurement<mg>[:ENABle].........................................................................................614
MEASurement<mg>:SOURce......................................................................................... 614
MEASurement<mg>:FSRC............................................................................................. 614
MEASurement<mg>:SSRC............................................................................................. 615
MEASurement<mg>:MAIN..............................................................................................615
MEASurement<mg>:ENVSelect...................................................................................... 615
Automatic measurements