Rohde & Schwarz MXO 4 Series - Page 615

Remote control commandsMXO 4 Series
615User Manual 1335.5337.02 ─ 07
Parameters:
<Source> NONE | C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 |
D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15 | M1 | M2 | M3 | M4 |
M5
Usage: Asynchronous command
MEASurement<mg>:SSRC <Source2>
Defines the second measurement source.
The command is an alternative to MEASurement<mg>:SOURce.
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<Source2> NONE | C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 |
D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15 | M1 | M2 | M3 | M4 |
M5
Usage: Asynchronous command
Manual operation: See "Clock source" on page 234
MEASurement<mg>:MAIN <MeasType>
Defines the measurement that is used as a source for math calculations and result
analysis.
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<MeasType> HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta |
MEAN | RMS | STDDev | CRESt | POVershoot | NOVershoot |
AREA | RTIMe | FTIMe | PPULse | NPULse | PERiod |
FREQuency | PDCYcle | NDCYcle | CYCarea | CYCMean |
CYCRms | CYCStddev | CYCCrest | CAMPlitude | CMAXimum |
CMINimum | CPDelta | PULCnt | DELay | PHASe | BWIDth |
EDGecount | SETup | HOLD | SHT | SHR | DTOTrigger |
SLERising | SLEFalling
Usage: Asynchronous command
MEASurement<mg>:ENVSelect <EnvelopeCurve>
Relevant only for measurements on envelope waveforms. It selects the envelope to be
used for measurement.
Prerequisites:
●
ACQuire:TYPE on page 520 is set to ENVElope.
Automatic measurements