Protocol analysisMXO 4 Series
315User Manual 1335.5337.02 ─ 07
Example:
When the "Show threshold lines" is enabled, the threshold lines and the hysteresis are
shown on the display for a few seconds. Afterwards only the threshold line is visible.
Figure 13-1: Threshold lines, shortly after Show threshold lines is enabled
Remote command:
SBUS<m>:THReshold on page 705
13.1.3 Advanced
Some protocols have additional more advanced settings. They are displayed in the
"Advanced" tab.
The settings are protocol specific and are described in the corresponding protocol
chapter.
13.1.4 Display
For all protocols, you can select to display the decoded signal as a table and to show
the binary signal on the screen.
Basics of protocol analysis
To Next Page
Loading...
