Protocol analysisMXO 4 Series
316User Manual 1335.5337.02 ─ 07
Show decode table
Opens a table with decoded data of the serial signal. The function requires the option
for the analyzed protocol.
Decode results are protocol-specific.
Remote command:
SBUS<sb>:RESult on page 704
Decode layer
Selects the decode layer.
Decoding is performed in several steps, and the results are presented in the decode
table. The decode layer selects an interim step for which the decoding result is shown
in the honeycomb display.
The available values are protocol-specific.
"Off"
No decode layer is displayed.
"Edges"
All edges.
"Bits"
All bits.
"Words"
All words.
Data format
Sets the data format for the values displayed in the decode table and in the combs of
the decoded signal.
Basics of protocol analysis
To Next Page
Loading...
