Rohde & Schwarz MXO 4 Series - Digital Channels

Remote control commandsMXO 4 Series
844User Manual 1335.5337.02 ─ 07
17.17.1 Digital channels
All DIGital: commands affect only the settings of the first MSO bus (Logic1). The
settings of all other logic groups (Logic 2, 3,4) remain unchanged.
DIGital<m>:LABel.......................................................................................................... 844
DIGital<m>:SIZE............................................................................................................844
DIGital<m>:SKEW......................................................................................................... 844
DIGital<m>:STATe..........................................................................................................845
DIGital<m>:TECHnology.................................................................................................845
DIGital<m>:THCoupling..................................................................................................845
DIGital<m>:THReshold...................................................................................................846
DIGital<m>:LABel <Label>
Sets a name for the indicated digital channel. The name is displayed in the diagram.
The setting affects only the settings of the first MSO bus (Logic1).
You can set the label for all buses with PBUS<pb>:BIT<n>:LABel
Suffix:
<m>
.
0..15
Selects the digital channel.
Parameters:
<Label> String containing the channel name
Usage: Asynchronous command
DIGital<m>:SIZE <Size>
Suffix:
<m>
.
0..15
The suffix is irrelevant.
Parameters:
<Size>
Usage: Asynchronous command
DIGital<m>:SKEW <Skew>
Sets an individual delay for each digital channel to time-align it with other digital chan-
nels. The skew value compensates delays that are known from the circuit specifics or
caused by the different length of cables.
The setting affects only the settings of the first MSO bus (Logic1).
You can set the skew for all buses with PBUS<pb>:BIT<n>:SKEW.
Suffix:
<m>
.
0..15
Selects the digital channel.
Mixed signal option (option R&S MXO4-B1)