Rohde & Schwarz MXO 4 Series - I²C (Option R&S MXO4-K510)

Remote control commandsMXO 4 Series
725User Manual 1335.5337.02 ─ 07
SBUS<sb>:SPI:FRAMe<fr>:WORD<w>:STARt?
Returns the start time of the specified data word.
Suffix:
<sb>
.
1...4, index of the serial bus
<fr> index of the frame
<w> index of the word
Return values:
<FrameWordStart> Range: -1E+26 to 1E+26
Increment: 1E-10
*RST: 0
Default unit: s
Usage: Query only
Asynchronous command
SBUS<sb>:SPI:FRAMe<fr>:WORD<w>:STOP?
Returns the end time of the specified data word.
Suffix:
<sb>
.
1...4, index of the serial bus
<fr> index of the frame
<w> index of the word
Return values:
<FrameWordStop> Range: -1E+26 to 1E+26
Increment: 1E-10
*RST: 0
Default unit: s
Usage: Query only
Asynchronous command
17.16.3 I²C (option R&S MXO4-K510)
Before MXO 4 can accept the specific bus commands, make sure that:
●
The decoding of the specified bus is enabled with SBUS<sb>[:STATe].
●
The bus is set to the correct type with SBUS<sb>:TYPE.
● Configuration.........................................................................................................726
● Trigger...................................................................................................................729
● Filter...................................................................................................................... 733
● Decode results...................................................................................................... 738
Protocols