Protocol analysisMXO 4 Series
365User Manual 1335.5337.02 ─ 07
The "Export results" dialog opens.
For details, see Chapter 13.1.7, "Export protocol results", on page 318.
2. Select the details that you want to export and the file format.
3. Tap "Save as".
4. Key in a name and select the file format.
Remote commands
Remote commands to retrieve decode results are described in Chapter 17.16.4.4,
"Decode results", on page 759.
13.4.6 Performing UART decoding
This chapter explains step by step how to configure and decode the UART bus.
For more information on decoding UART, you can also refer to the video, available on
the Rohde & Schwarz YouTube channel: Decoding UART with MXO Series Oscillo-
scope.
13.4.6.1 Configuring UART signals
For configuration, assign the lines to the input channels, and define the active states
and the logical thresholds.
For details on configuration settings, see UART configuration.
1. Tap the "Bus" activator in the bottom right of the screen.
2. Select the tab of the bus that you want to set up, for example "SB1".
3. Tap the "Protocol type" button. Select the protocol: "UART".
4. Tap on "State" to enable the decoding.
An SPI shortcut appears at the bottom left of the screen. Tap on the shortcut for a
quick access to the "UART / RS232" dialog settings.
5. Select the correct channels for each active line: "Tx" and "Rx".
6. Set the "Bit rate".
UART (option R&S
MXO4-K510)
To Next Page
Loading...
