Rohde & Schwarz MXO 4 Series - Using History

Waveform analysisMXO 4 Series
196User Manual 1335.5337.02 ─ 07
Available acqs
Number of acquisitions that is saved in the memory and available for history viewing. It
is also the number of acquisitions in a fast segmentation acquisition series.
Remote command:
ACQuire:AVAilable? on page 516
Current acq
Index of the current acquisition, same as Current acq in the history setup.
Time
Shows the timestamp of the current acquisition. See "Time stamp" on page 195.
Auto repeat
If selected, the playback of the selected history segments repeats automatically.
Remote command:
ACQuire:HISTory:REPLay on page 587
Play
Starts and stops the replay of the history waveforms. See also: "Player" on page 194.
8.3.4 Using history
You can access the history waveforms in two ways:
●
Display a particular acquisition.
●
Replay all or a part of the saved waveforms to track the signal run.
To open the history and get information
1. Press the [History] key on the front panel.
A running acquisition is stopped, the history mode is enabled and the quick-access
"History" dialog box is displayed. The [History] key lights up as long as the history
mode is active.
2. Open the full configuration dialog box:
●
Tap the
icon.
● Open "Menu" > "Acquisition" dialog > "History" tab.
To display a particular acquisition
You can analyze a selected history waveform, and save it to file.
► In the quick-access "History" dialog box, enter the number of the required acquisi-
tion in the "Current acq" field. The newest acquisition always has the index "0",
older acquisitions have a negative index.
History