Waveform analysisMXO 4 Series
197User Manual 1335.5337.02 ─ 07
Alternatively, you can configure and start the history display from the "History" configu-
ration dialog box:
1. Open the "History" configuration tab.
2. If the history mode is off (the [History] key is not illuminated), select "Show history".
3. Drag the slider to the required acquisition. The current number is shown in the
"Current acq" field.
Alternatively, enter the number of the required acquisition in the "Current acq" field.
To save a single history waveform
1. Select and display the required history waveform as described in "To display a par-
ticular acquisition" on page 196.
2. Save the selected waveform using "Save/Recall" > "Save" tab > "Waveform". For
details, see Chapter 12.2, "Save and recall waveform data", on page 297.
To replay history waveforms
If you want to see the complete acquisition series without any setup, simply tap in the
quick-access "History" dialog box. For specific analysis of history data, use the history
"Viewer" setup.
1. Open the "History" configuration dialog tab.
2. If the history mode is off (the [History] key is not illuminated), enable "Show his-
tory".
3.
Tap to start.
To exit the history
► Choose one of the following ways:
● Close the quick-access "History" dialog box.
● In the "History" configuration tab, disable "Show history".
● Start the acquisition.
History
To Next Page
Loading...
