Rohde & Schwarz MXO 4 Series - Measurement-Specific Settings

Remote control commandsMXO 4 Series
616User Manual 1335.5337.02 ─ 07
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<EnvelopeCurve> MIN | MAX | BOTH
MIN
Measures on the lower envelope.
MAX
Measures on the upper envelope.
BOTH
The envelope is ignored, and the waveform is measured as
usual.
*RST: BOTH
Usage: Asynchronous command
Manual operation: See "Envelope" on page 233
17.12.2 Measurement-specific settings
MEASurement<mg>:AMPTime:CSLope........................................................................... 616
MEASurement<mg>:AMPTime:ESLope........................................................................... 616
MEASurement<mg>:AMPTime:PTCount.......................................................................... 617
MEASurement<mg>:AMPTime:PSLope........................................................................... 617
MEASurement<mg>:AMPTime:DELay<n>:DIRection.........................................................617
MEASurement<mg>:AMPTime:DTOTrigger<n>:SLOPe..................................................... 618
MEASurement<mg>:AMPTime:DELay<n>:SLOPe............................................................ 618
MEASurement<mg>:GATE............................................................................................. 619
MEASurement<mg>:REFLevel<sc>:REFerence............................................................... 619
MEASurement<mg>:AMPTime:CSLope <SetHoldClkSlp>
Sets the edge of the clock from which the setup and hold times are measured.
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<SetHoldClkSlp> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
Manual operation: See "Clock slope" on page 234
MEASurement<mg>:AMPTime:ESLope <EdgesSlope>
Sets the edge direction to be counted: rising edges, falling edges, or both. The setting
is only relevant for edge count measurement MEASurement<mg>:MAIN is set to
EDGecount.
Automatic measurements