Rohde & Schwarz MXO 4 Series - Page 612

Remote control commandsMXO 4 Series
612User Manual 1335.5337.02 ─ 07
Manual operation: See "Inverse color" on page 309
HCOPy:IMMediate<m>:NEXT
Starts the output of the next display image, depending on the HCOPy:
DESTination<m> destination setting.
If the screenshot is saved to a file, the file name used in the last saving process is
automatically counted up to the next unused name. To define the file name, use
MMEMory:NAME.
Suffix:
<m>
.
1..2
Selects the output configuration.
Example: See Chapter 17.4.2, "Saving screenshots to file", on page 478.
Usage: Asynchronous command
HCOPy:IMMediate<m>[:DUM]
Starts the immediate output of the display image, depending on the HCOPy:
DESTination<m> destination setting.
To define the file name, use MMEMory:NAME. Existing files are overwritten by the
HCOP:IMMM command.
To get a correct screenshot of the diagrams, results, and dialog boxes, turn on the dis-
play using SYSTem:DISPlay:UPDate.
Suffix:
<m>
.
1..2
Selects the output configuration.
Example: See Chapter 17.4.2, "Saving screenshots to file", on page 478.
Usage: Event
Asynchronous command
HCOPy:ISBA <IncludeSignBarScpi>
If enabled, the screenshot shows the signal bar below the diagram area.
Parameters:
<IncludeSignBarScpi>ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Include signal bar" on page 309
Data management