Rohde & Schwarz MXO 4 Series - Page 484

Remote control commandsMXO 4 Series
484User Manual 1335.5337.02 ─ 07
Example:
FORMat:DATA REAL,32
FORMat:DATA?
REAL,32
Usage: SCPI confirmed
Asynchronous command
Manual operation: See "Transfer data format" on page 78
FORMat:BPATtern <BtPattFmt>
Sets the number format for remote bit pattern queries on serial protocols.
Parameters:
<BtPattFmt> DEC | HEX | OCT | BIN | ASCII | ASCii | STRG
*RST: HEX
Usage: Asynchronous command
Manual operation: See "Bit pattern format" on page 78
SYSTem:DISPlay:UPDate <DisplayUpdate>
Defines whether the display is updated while the instrument is in the remote state. If
the display is switched off, the normal GUI is replaced by a static image while the
instrument is in the remote state. Switching off the display can speed up the measure-
ment. This is the recommended state.
Parameters:
<DisplayUpdate> ON | OFF
ON| 1: Display is shown and updated during remote control.
OFF| 0: Display shows static image during remote control.
*RST: OFF
Example:
SYSTem:DISPlay:UPDate 1
Switch on the display update.
Usage: Asynchronous command
SYSTem:DISPlay:MESSage:STATe <DispMessSt>
Enables and disables the display of an additional text in remote control.
To define the text, use SYSTem:DISPlay:MESSage[:TEXT].
Parameters:
<DispMessSt> ON | OFF
*RST: OFF
Usage: Asynchronous command
General remote settings