Rohde & Schwarz MXO 4 Series - Page 407

Protocol analysisMXO 4 Series
407User Manual 1335.5337.02 ─ 07
Use GSID, GSID (hex)
Enables the use of the group sub ID (GSID). You can then enter a value for the "GSID
(hex)".
Remote command:
SBUS<sb>:SPMI:GSIDenable on page 813
SBUS<sb>:SPMI:GIDValue on page 812
Glitch filter, Glitch width
A glitch filter can help to filter out short duration voltage spikes/ glitches that can occur
on the communication line.
If "Glitch filter" > "On" you can set the "Glitch width", the duration of time that noise
lasts before being considered as a glitch.
Remote command:
SBUS<sb>:SPMI:GTCHenable on page 813
SBUS<sb>:SPMI:GTWDith on page 813
13.7.1.2 Threshold settings
Access: [Apps] key > "Protocol" tab > "SPMI" > "Thresholds".
Threshold
Sets the threshold for the data/clock channel. Enter the value directly in the fields.
Additional to the threshold, you can also set a hysteresis.
Remote command:
SBUS<sb>:SPMI:SCLK:THReshold on page 814
SBUS<sb>:SPMI:SDATa:THReshold on page 815
SPMI (option R&S
MXO4-K550)