Rohde & Schwarz MXO 4 Series - Page 813

Remote control commandsMXO 4 Series
813User Manual 1335.5337.02 ─ 07
SBUS<sb>:SPMI:GSIDenable <UseGSID>
Enables the use of the group sub ID (GSID). You can set the GSID with SBUS<sb>:
SPMI:GIDValue.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<UseGSID> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Use GSID, GSID (hex)" on page 407
SBUS<sb>:SPMI:GTCHenable
<UseGlitchFilter>
Enables the glitch filter. A glitch filter can help to filter out short duration voltage spikes/
glitches that can occur on the communication line.
You can set the glitch filter width with SBUS<sb>:SPMI:GTWDith.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<UseGlitchFilter> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Glitch filter, Glitch width" on page 407
SBUS<sb>:SPMI:GTWDith <GlitchFilterWdt>
Sets the duration of time that noise lasts before being considered as a glitch.
This is available, if SBUS<sb>:SPMI:GTCHenable is set to ON.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<GlitchFilterWdt> Range: 1E-15 to 1000000000
Increment: 1E-10
*RST: 1E-09
Default unit: s
Usage: Asynchronous command
Manual operation: See "Glitch filter, Glitch width" on page 407
Protocols