Rohde & Schwarz MXO 4 Series - Page 815

Remote control commandsMXO 4 Series
815User Manual 1335.5337.02 ─ 07
Manual operation: See "Threshold" on page 407
SBUS<sb>:SPMI:SDATa:SOURce <DataSource>
Sets the source of the data line.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<DataSource> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9
| D10 | D11 | D12 | D13 | D14 | D15 | M1 | M2 | M3 | M4 | M5 |
R1 | R2 | R3 | R4
Usage: Asynchronous command
Manual operation: See "SDATA" on page 406
SBUS<sb>:SPMI:SDATa:THReshold
<SDATA Thres>
Sets a user-defined threshold value for the source data line.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<SDATA Thres>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 407
SBUS<sb>:SPMI:POSition <SPMI position>
Sets the vertical position of the SPMI signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<SPMI position>
Usage: Asynchronous command
SBUS<sb>:SPMI:SCALe <SPMI scale>
Sets the vertical position of the SPMI signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<SPMI scale>
Usage: Asynchronous command
Protocols