Rohde & Schwarz MXO 4 Series - Page 592

Remote control commandsMXO 4 Series
592User Manual 1335.5337.02 ─ 07
REFCurve<rc>:SAVE
Saves the reference waveform to the file selected by REFCurve<rc>:NAME.
Suffix:
<rc>
.
1...4, index of the reference waveform
Usage: Event
Asynchronous command
Manual operation: See "Save" on page 201
REFCurve<rc>:SOURce <Source>
Selects the source waveform from the active waveforms, e.g. input channels, math
waveforms, or spectrum.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<Source> C1 | C2 | C3 | C4 | M1 | M2 | M3 | M4 | M5 | R1 | R2 | R3 | R4 |
SPECMAXH1 | SPECMINH1 | SPECNORM1 | SPECAVER1
Source of the reference waveform.
Usage: Asynchronous command
Manual operation: See "Source" on page 200
REFCurve<rc>:STATe <State>
Enables the display of the reference waveform in the diagram.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Show" on page 200
REFCurve<rc>:UPDate
Copies the selected source waveform with all its settings to the memory of the refer-
ence waveform. If there is a previously defined reference waveform in this memory, it is
updated by the current source waveform. If the acquisition is running, the reference
waveform is a snapshot.
Suffix:
<rc>
.
1...4, index of the reference waveform
Waveform analysis