Rohde & Schwarz MXO 4 Series - Page 201

Waveform analysisMXO 4 Series
201User Manual 1335.5337.02 ─ 07
Create/update
Copies the selected source waveform with all its settings to the memory of the refer-
ence waveform. If there is a previously defined reference waveform in this memory, it is
updated by the current source waveform. If the acquisition is running, the reference
waveform is a snapshot.
A progress bar informs you about the process, see "Progress information" on page 72.
Remote command:
REFCurve<rc>:UPDate on page 592
Clear
The selected reference waveform disappears, its memory is deleted.
Remote command:
REFCurve<rc>:CLEar on page 590
Save
Saves the reference waveform. The complete reference waveform is stored in a REF
file and can be reloaded later. Other formats, like CSV, are meant for further process-
ing in other applications.
A progress bar informs you about the process, see "Progress information" on page 72.
See also:
●
Chapter 12.2, "Save and recall waveform data", on page 297
●
Chapter 12.2.3, "Waveform export files", on page 301
Remote command:
REFCurve<rc>:SAVE on page 592
To abort the saving, use REFCurve<rc>:ABORt on page 590.
Recall
Opens a file selection dialog box and loads the selected reference waveform file.
Note that reference waveforms can be loaded only from REF files.
Remote command:
REFCurve<rc>:OPEN on page 591
8.4.2.2 Reference waveform properties
Access: [Ref] key > "Properties" tab
Reference waveforms