Rohde & Schwarz MXO 4 Series - Page 591

Remote control commandsMXO 4 Series
591User Manual 1335.5337.02 ─ 07
REFCurve<rc>:NAME <Name>
Defines the name of the reference waveform file to be loaded, saved or deleted.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<Name>
Usage: Asynchronous command
REFCurve<rc>:OFFSet <VerticalOffset>
The vertical offset moves the reference waveform vertically. Enter a value with the unit
of the waveform.
Suffix:
<rc>
.
1...4, index of the reference waveform
Parameters:
<VerticalOffset> Range: -1E+26 to 1E+26
Increment: 1E-06
*RST: 0
Default unit: V
Usage: Asynchronous command
Manual operation: See "Vertical offset" on page 204
REFCurve<rc>:OPEN
Loads the reference waveform file selected by REFCurve<rc>:NAME on page 591.
Note that reference waveforms can be loaded only from .ref files.
Suffix:
<rc>
.
1...4, index of the reference waveform
Usage: Event
Asynchronous command
Manual operation: See "Recall" on page 201
REFCurve<rc>:RESTore
Applies the original settings of the reference waveform to the horizontal and vertical
settings of the selected waveform.
Suffix:
<rc>
.
1...4, index of the reference waveform
Usage: Setting only
Asynchronous command
Manual operation: See "Restore settings" on page 203
Waveform analysis