Rohde & Schwarz MXO 4 Series - Page 323

Protocol analysisMXO 4 Series
323User Manual 1335.5337.02 ─ 07
State
Enables the decoding of the selected bus. The signal icon of the bus appears on the
signal bar.
SCLK,MOSI,MISO,CS
Sets the input channel for the respective line:
●
SCLK: clock line
●
MOSI line
●
MISO line
●
CS: chip select
Alternatively, digital channels can be used if MSO option R&S MXO4-B1 is installed.
Digital and analog channels cannot be used at the same time.
For triggering on a serial bus, analog or digital channel sources are required.
Remote command:
SBUS<sb>:SPI:MISO:SOURce on page 709
SBUS<sb>:SPI:MOSI:SOURce on page 711
SBUS<sb>:SPI:SCLK:SOURce on page 711
SBUS<sb>:SPI:CSELect:SOURce on page 708
Clock polarity
Two settings define the clock mode: the clock polarity and the clock phase. Together,
they determine the edges of the clock signal on which the data are driven and sam-
pled.
A master/slave pair must use the same parameter pair values to communicate. The
clock phase defines the slope. It selects if data is stored with the rising or falling slope
of the clock. The slope marks the begin of a new bit.
Polarity: MOSI, MISO, CS
Selects if the transmitted signal for the respective line is active high (high = 1) or active
low (low = 1).
For triggering on a serial bus, analog or digital channel sources are required.
Remote command:
SBUS<sb>:SPI:MISO:POLarity on page 709
SBUS<sb>:SPI:MOSI:POLarity on page 710
SBUS<sb>:SPI:CSELect:POLarity on page 708
Bit order
Selects the bit order, which determines if the data of the messages starts with MSB
(most significant bit) or LSB (least significant bit).
Remote command:
SBUS<sb>:SPI:BORDer on page 707
Word length
Sets the word length (or symbol size), which is the number of bits in a message. The
maximum word length is 32 bit.
Remote command:
SBUS<sb>:SPI:WSIZe on page 712
SPI bus (option R&S
MXO4-K510)