Rohde & Schwarz MXO 4 Series - Page 255

Spectrum analysisMXO 4 Series
255User Manual 1335.5337.02 ─ 07
Threshold
Peak excursion
1 2
Remote command:
CALCulate:SPECtrum<sp>:PEXCursion on page 652
CURSor<cu>:PEXCursion on page 644
Max results
Sets the maximum number of measurement results that are listed in the result table.
Remote command:
CALCulate:SPECtrum<sp>:PLISt:MAXCount on page 655
Result mode
Selects how the measurement results are displayed.
"Absolute"
The peaks are shown in absolute value, dBm.
"Relative"
The level of the carrier is shown in absolute value dBm. The values of
the peaks are shown relatively to the carrier in dBc.
Remote command:
CALCulate:SPECtrum<sp>:PLISt:MODE on page 656
Show frequency
Includes the frequency of the detected peak in the diagram labels.
Remote command:
CALCulate:SPECtrum<sp>:PLISt:LABel:FREQuency[:STATe] on page 657
Source
Selects the source of the peak table. You can select one of the traces that is enabled
with Traces.
Remote command:
CALCulate:SPECtrum<sp>:PLISt:SOURce on page 656
Spectrum peak list