Rohde & Schwarz MXO 4 Series - Page 644

Remote control commandsMXO 4 Series
644User Manual 1335.5337.02 ─ 07
Suffix:
<cu>
.
1...2, index of the cursor set
Usage: Event
Asynchronous command
Manual operation: See "Next peak left" on page 216
CURSor<cu>:MAXimum:RIGHt
Cursor 2 is set to the next peak to the right of the current position.
Suffix:
<cu>
.
1...2, index of the cursor set
Usage: Event
Asynchronous command
Manual operation: See "Next peak right" on page 216
CURSor<cu>:MAXimum:NEXT
Cursor 2 is set to the next smaller absolute peak from the current position.
Suffix:
<cu>
.
1...2, index of the cursor set
Usage: Event
Asynchronous command
Manual operation: See "Next peak" on page 216
CURSor<cu>:PEXCursion <Value>
Sets the minimum level by which the waveform must rise or fall so that it will be identi-
fied as a maximum or a minimum by the search functions.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<Value>
Usage: Asynchronous command
Manual operation: See "Peak excursion" on page 216
CURSor<cu>:THReshold <Value>
Sets an absolute threshold as an additional condition for the peak search. Only peaks
that exceed the threshold are detected.
Suffix:
<cu>
.
1...2, index of the cursor set
Cursor measurements