Rohde & Schwarz MXO 4 Series - Page 656

Remote control commandsMXO 4 Series
656User Manual 1335.5337.02 ─ 07
Parameters:
<MaxNoRess> Range: 1 to 1000
Increment: 1
*RST: 10
Usage: Asynchronous command
Manual operation: See "Max results" on page 255
CALCulate:SPECtrum<sp>:PLISt:MODE <ResultMode>
Selects how the measurement results are displayed.
Suffix:
<sp>
.
1
Parameters:
<ResultMode> ABS | REL
*RST: ABS
Usage: Asynchronous command
Manual operation: See "Result mode" on page 255
CALCulate:SPECtrum<sp>:PLISt:SOURce <Source>
Selects the source of the peak table. You can select one of the traces that is enabled
with Traces.
Suffix:
<sp>
.
1
Parameters:
<Source> SPECMAXH1 | SPECMINH1 | SPECNORM1 | SPECAVER1
Usage: Asynchronous command
Manual operation: See "Source" on page 255
CALCulate:SPECtrum<sp>:PLISt:SPOW <ShwPeaksOnWfm>
Displays a box with a description for each detected peak in the spectrum, including the
magnitude.
If CALCulate:SPECtrum<sp>:PLISt:LABel:FREQuency[:STATe] is ON, the fre-
quency values are also displayed.
Suffix:
<sp>
.
1
Parameters:
<ShwPeaksOnWfm> ON | OFF
*RST: OFF
Usage: Asynchronous command
Spectrum analysis