Rohde & Schwarz MXO 4 Series - Page 253

Spectrum analysisMXO 4 Series
253User Manual 1335.5337.02 ─ 07
The number of determined peaks can be defined. You can sort the results by frequency
or power value, and the peak labels are adjusted accordingly.
Also, you can adjust some of the display settings, see Chapter 5.3.4, "Peak list",
on page 88.
To analyze the peaks in a spectrum, you can also use cursors on the spectrum wave-
form and peak search functions. For details, see Chapter 9.1.3.3, "Peak search tab",
on page 215.
Remote commands query peak results and to change the results display:
●
CALCulate:SPECtrum<sp>:PLISt:RESult[:VALue]? on page 657
●
CALCulate:SPECtrum<sp>:PLISt:SORT:COLumn on page 657
●
CALCulate:SPECtrum<sp>:PLISt:SORT:ORDer on page 657
●
CALCulate:SPECtrum<sp>:PLISt:LABel:INVert on page 658
Peak table
Enables the display of the peak table.
Remote command:
CALCulate:SPECtrum<sp>:PLISt[:STATe] on page 655
Peak on waveform
Displays a box with a description for each detected peak in the spectrum, including the
magnitude. If "Show frequency" is enabled, the frequency values are also displayed.
If this option is disabled, the peaks are marked on the diagram only with a point
marker.
Spectrum peak list