MeasurementsMXO 4 Series
215User Manual 1335.5337.02 ─ 07
Show values
Shows the measured values in the cursor labels.
Remote command:
CURSor<cu>:DISPlay:VALues on page 639
Vertical cursor 1, Vertical cursor 2
Defines the label to be displayed with the vertical cursor lines. By default, the cursors
are labeled as Cu1.1, Cu1.2, Cu2.1, ...
Remote command:
CURSor<cu>:VERTical<n>:LABel on page 639
Horizontal cursor 1, Horizontal cursor 2
Defines the label to be displayed with the horizontal cursor lines. By default, the cur-
sors are labeled as Cu1.1, Cu1.2, Cu2.1, ...
Remote command:
CURSor<cu>:HORizontal<n>:LABel on page 639
9.1.3.3 Peak search tab
Access: [Cursor] key > "Peak search" tab
The settings on this tab are only available in spectrum mode, i.e. the source of the cur-
sor measurement is a spectrum. In this case, the cursors can indicate the results of a
peak search on the waveform. You can define which peaks the instrument determines
by defining the noise reject settings.
Cursor measurements
To Next Page
Loading...
