Rohde & Schwarz MXO 4 Series - Page 639

Remote control commandsMXO 4 Series
639User Manual 1335.5337.02 ─ 07
CURSor<cu>:HORizontal<n>:LABel <Label>
Defines the label to be displayed with the horizontal cursor lines. By default, the cur-
sors are labeled as Cu1.1, Cu1.2, Cu2.1, ...
Suffix:
<cu>
.
1...2, index of the cursor set
<n> 1..2
Number of the cursor line
Parameters:
<Label> String with the cursor label
Example:
CURSor1:HORizontal1:LABel 'Cu1H1'
CURSor1:HORizontal2:LABel "Cu1H2"
Usage: Asynchronous command
Manual operation: See "Horizontal cursor 1, Horizontal cursor 2" on page 215
CURSor<cu>:VERTical<n>:LABel
<Label>
Defines the label to be displayed with the vertical cursor lines. By default, the cursors
are labeled as Cu1.1, Cu1.2, Cu2.1, ...
Suffix:
<cu>
.
1...2, index of the cursor set
<n> 1..2
Number of the cursor line
Parameters:
<Label> String with the cursor label
Example:
CURSor2:VERTical1:LABel 'Cu2V1'
CURSor2:VERTical2:LABel "Cu2V2"
Usage: Asynchronous command
Manual operation: See "Vertical cursor 1, Vertical cursor 2" on page 215
CURSor<cu>:DISPlay:VALues <AddValuesLabel>
Shows the measured values in the cursor labels.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<AddValuesLabel> ON | OFF
*RST: OFF
Usage: Asynchronous command
Manual operation: See "Show values" on page 215
Cursor measurements