Rohde & Schwarz MXO 4 Series - Page 640

Remote control commandsMXO 4 Series
640User Manual 1335.5337.02 ─ 07
CURSor<cu>:SIAD <ShwInAllDiags>
Shows the enabled cursor measurements in all active diagrams of the time domain.
In the spectrum domain, the setting is disabled. The cursors are shown only on the
source spectrum of the measurement.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<ShwInAllDiags> ON | OFF
*RST: ON
Usage: Asynchronous command
Manual operation: See "Show in all diagrams" on page 214
CURSor<cu>:XCOupling
<Coupling>
Defines the positioning mode of the vertical cursor.
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<Coupling> ON | OFF
ON
Moving one cursor line moves the other cursor line too. The cur-
sor lines always remain a fixed distance.
OFF
Each cursor line is positioned independently.
*RST: OFF
Usage: Asynchronous command
Manual operation: See "X, Y" on page 214
CURSor<cu>:YCOupling <Coupling>
Defines the positioning mode of the horizontal cursor. If the horizontal cursor lines track
the waveform, the y-coupling is irrelevant (CURSor<cu>:TRACking[:STATe] is ON).
Suffix:
<cu>
.
1...2, index of the cursor set
Parameters:
<Coupling> ON | OFF
ON
Moving one cursor line moves the other cursor line too. The cur-
sor lines always remain a fixed distance.
OFF
Each cursor line is positioned independently.
Cursor measurements