MeasurementsMXO 4 Series
214User Manual 1335.5337.02 ─ 07
X, Y
Couple the horizontal or vertical cursor lines so that the distance between the two lines
remains the same if one cursor is moved. "X" couples the vertical cursor lines, and "Y"
couples the horizontal cursor lines.
Remote command:
CURSor<cu>:XCOupling on page 640
CURSor<cu>:YCOupling on page 640
Show in all diagrams
Shows the enabled cursor measurements in all active diagrams of the time domain.
In the spectrum domain, the setting is disabled. The cursors are shown only on the
source spectrum of the measurement.
Remote command:
CURSor<cu>:SIAD on page 640
Show label
Shows the cursor labels in the diagram.
Remote command:
CURSor<cu>:LABel on page 638
Cursor measurements
To Next Page
Loading...
