Instrument setupMXO 4 Series
76User Manual 1335.5337.02 ─ 07
Device name
Indicates the currently defined host name. This value is required to configure the
instrument for work in a network.
You can change the host name here. After changing the host name, you have to reboot
the instrument.
NOTICE! Risk of network problems. Incorrect configuration of the host name can cre-
ate network problems. Consult your network administrator before changing the name.
Remote command:
SYSTem:COMMunicate:NET[:HOSTname] on page 485
Automatic IP (DHCP)
If enabled, the IP address of the oscilloscope is obtained automatically.
IP address
Shows the current IP address of the instrument. If "Automatic IP (DHCP)" is "Off", you
can change the IP address here. For complete manual configuration, select
"Advanced". See also: Chapter 16.1, "Connecting the instrument to the network
(LAN)", on page 451.
Web Ifc Password
Password for LAN configuration. The default password is LxiWebIfc.
LAN reset
Resets the LAN configuration to its default settings using the network configuration
reset mechanism (LCI) for the instrument.
System settings
To Next Page
Loading...
