Rohde & Schwarz MXO 4 Series - Page 84

Instrument setupMXO 4 Series
84User Manual 1335.5337.02 ─ 07
By default, various colors are assigned to the different waveform types for better visibil-
ity and distinguishability. You can change the color assignment and select another
color or a color table to waveforms.
Color source
Selects the waveform to which the color or the color table is assigned.
Use color table
If enabled, the selected waveform is displayed according to its assigned color table.
If disabled, the selected color is displayed, and the intensity of the signal color varies
according to the cumulative occurrence of the values.
Remote command:
DISPlay:COLor:SIGNal:USE on page 494
Assigned color table
Assigns a color table to the source waveform instead of a dedicated color. Color tables
define the color of the waveform pixels depending on the cumulative occurrence of the
associated values.
The following color tables are provided:
●
"False colors": color changes gradually in a wide color spectrum.
●
"Single Event": single events and very seldom events appear yellow, a higher
cumulative occurrence is shown with blue color. This view helps to identify specific
events.
●
"Spectrum": colors display the wavelengths of the light. Low cumulative occurrence
is displayed blue like high wavelength.
●
"Temperature": color changes gradually from blue (low temperature) to red (high
temperature) with increasing cumulative occurrence.
Remote command:
DISPlay:COLor:SIGNal:ASSign on page 494
Appearance settings