Rohde & Schwarz SMU200A - Settings Displayed in the Header Section

Manual Operation
R&S
®
SMU200A
90Operating Manual 1007.9845.32 ─ 15
●
The block diagram shows the instrument configuration, the signal characteristic as
well as the inputs and outputs used and permits interactive operation via graphics
elements. Active menus and graphs are displayed on top of the block diagram.
●
Winbar with labelled softkeys for menu display.
The block diagram in the figure below shows a fully equipped instrument.
Fig. 4-1: Block diagram of a fully equipped two-path R&S Signal Generator
4.2.1 Settings Displayed in the Header Section
Frequency/level settings and a few status messages (see chapter 4.2.2, "Status Infor-
mation and Messages", on page 91) are displayed in the header field of the screen.
The display may vary depending on the instrument's operating mode:
●
In the case of two-path instruments, the RF information for the two paths is displayed
in two lines.
●
In the sweep mode, the current frequency or level of the output signal is displayed.
The status message "ListMode" is displayed in the info line.
●
In the list mode, neither the current frequency nor level is displayed, the indication is
dimmed.
●
If user correction is active, the status message "UCorr" is displayed in the info line.
●
In the case of digital modulation, "Freq" indicates the frequency, "PEP" the peak
envelope power and "Level" the average level.
The value displayed in the "Freq" and "Level" filed does not consider any offset set.
For more information see chapter 5.5.2, "RF Frequency Settings", on page 196 and
chapter 5.5.7.1, "Overview RF Level Settings", on page 216.
Display