Remote Control Commands
R&S
®
SMU200A
514Operating Manual 1007.9845.32 ─ 15
:BERT:RESult?
Queries the result of the last BER measurement/BLER measurement. The response
consists of seven results separated by commas. In the first measurement following the
start, intermediate results for the number of data bits/data blocks, error bits/errors and
error rate are also queried. In the following measurements (only for BERT:SEQ AUTO/
for BLER:SEQ AUTO) only the final results of each single measurement are queried
Note: At the end of a measurement, the restart of a new one is delayed until the first
measurement result has been queried with BERT:RES. The resulting brief measurement
interruption is irrelevant because the subsequent measurement will be synchronized
within 24 data bits.
BERT and BLER Subsystems
To Next Page
Loading...
